ProSciTech Safety Data Sheets ProSciTech Pty Ltd · proscitech.com.au

SAFETY DATA SHEET

2-Butoxy Ethanol

Version 1Last reviewed 15 May 2026Catalogue: 11820,EMS11820

1. Identification

Product Identifiers

Product Name
2-Butoxy Ethanol
Other Names
Butoxyethanol,
Product Number(s)
11820,EMS11820
CAS Number
111-76-2

Recommended use of the chemical and restriction on use

Where and restrictions (eg. Laboratory use.)

Company Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

Emergency Contact Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

2. Hazards Identification

Classification of the substance or mixture

  • GHS06 Skull and crossbones
  • Acute toxicity - dermal 3 H311 Toxic in contact with skin.
  • Acute toxicity - inhalation 3 H331 Toxic if inhaled.
  • GHS07
  • Acute toxicity - oral 4 H302 Harmful if swallowed.
  • Skin irritation 2 H315 Causes skin irritation.
  • Eye irritation 2A H319 Causes serious eye irritation.
  • Flammable liquids 4 H227 Combustible liquid.

Label Elements

Acute toxicity
Acute toxicity
Harmful / irritant
Harmful / irritant
Signal Words
None
Hazard Statement(s)
  • Combustible liquid.
  • Harmful if swallowed.
  • Toxic in contact with skin or if inhaled.
  • Causes skin irritation.
  • Causes serious eye irritation.
Precautionary Statement(s)
  • Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
  • Avoid breathing dust/fume/gas/mist/vapours/spray
  • Wash thoroughly after handling.
  • Do not eat, drink or smoke when using this product.
  • Use only outdoors or in a well-ventilated area.
  • Wear protective gloves/protective clothing/eye protection/face protection/hearing protection

Primary route(s) of entry

  • Primary route of entry:
  • Inhalation - breathing vapours or mists
  • Skin absorption (dermal exposure) - very significant for this chemical because it readily penetrates the skin

Human Health

Inhalation
  • Remove person to fresh air and keep comfortable for breathing.
  • Call a poison center/doctor.
Ingestion
  • Call a poison center/doctor if you feel unwell.
  • Rinse mouth.
Eyes
  • Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
  • Continue rinsing.
  • If eye irritation persists: Get medical advice/attention.
Skin
  • Wash with plenty of water.
  • Take off immediately all contaminated clothing and wash it before reuse.
  • If skin irritation occurs: Get medical advice/attention.

Environment

  • In case of fire: Use CO₂, powder or water spray to extinguish.
  • Store in a well-ventilated place. Keep container tightly closed.
  • Store locked up.
  • Dispose of contents/container in accordance with local/regional/national/international regulations.

3. Composition / Information on Ingredients

No information provided.

4. First Aid Measures

Ingestion
Immediately call a doctor.
Inhalation
  • Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist.
  • In case of unconsciousness place patient stably in side position for transportation.
Skin Contact
Immediately wash with water and soap and rinse thoroughly.
Eye Contact
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
Other Information
  • Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours
  • after the accident.

5. Firefighting Measures

Suitable extinguishing equipment

Fire
CO₂, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
HAZCHEM
No further relevant information available.

Special protective equipment and precautions for fire fighters

Mouth respiratory protective device.

6. Accidental Release Measures

Personal precautions, protective equipment and emergency procedures
Not required.
Environmental precautions
  • Dilute with plenty of water.
  • Do not allow to enter sewers/ surface or ground water.
Methods and materials for containment and clean up
  • Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
  • Dispose contaminated material as waste according to section 13.
  • Ensure adequate ventilation.

7. Handling and Storage

Precautions for safe handling
  • Precautions for safe handling Ensure good ventilation/exhaustion at the workplace.
  • Information about protection against explosions and fires: No special measures required.
Conditions for safe storage
  • Storage:
  • Requirements to be met by storerooms and receptacles: No special requirements.
  • Information about storage in one common storage facility: Not required.
  • Further information about storage conditions: Keep receptacle tightly sealed.
  • Specific end use(s) No further relevant information available.

8. Exposure Controls / Personal Protection

Exposure Standards

MaterialTWA ppmTWA mg/m³STEL ppmSTEL mg/m³
111-76-2 2-Butoxy Ethanol50 ppm240 mg/m³5 ppm24 mg/m³
Engineering controls
No further data; see section 7.

Personal protective equipment

Eye and face protection
  • Tightly sealed goggles.
  • General protective and hygienic measures:
  • Keep away from foodstuffs, beverages and feed.
  • Immediately remove all soiled and contaminated clothing.
  • Wash hands before breaks and at the end of work.
  • Avoid contact with the eyes and skin.
Skin protection
  • Protective gloves
  • The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
  • Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
  • Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
  • Material of gloves
  • The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer.
  • Penetration time of glove material
  • The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Respiratory protection
  • In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use
  • respiratory protective device that is independent of circulating air.

9. Physical and Chemical Properties

General information

Appearance
Colourless liquid
Odour
Characteristic
pH
7
Vapour Pressure
Not determined.
Density
0.9 g/cm³ (7.5105 lbs/gal) at 20 °C (68 °F)
Boiling Point
173.5 °C (344.3 °F)
Melting Point
-75 °C (-103 °F)
Solubility
with water at 20 °C (68 °F): 1 g/l
Specific Gravity of Density
Not determined.
Flash Point
67 °C (152.6 °F)
Flammable (Explosive) Limits
  • Lower: 1.1 Vol %
  • Upper: 12.7 Vol %
Ignition Temperature
Not determined.
Formula
C-H??O₂

10. Stability and Reactivity

Reactivity
No further relevant information available.
Chemical stability
Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications.
Possibility of hazardous reactions
No dangerous reactions known.
Conditions to avoid
No further relevant information available.
Incompatible materials
  • Incompatible materials: No further relevant information available.
  • Hazardous decomposition products: No dangerous decomposition products known.

11. Toxicological Information

Acute effects
  • LD/LC50 values that are relevant for classification:
  • Oral LD50 1,200 mg/kg (ATE)
  • 1,480 mg/kg (rat)
  • Dermal LD50 400 mg/kg (rab)
  • Inhalative LC50/4 h 3 mg/l (ATE)
Eye contact
Irritating effect
Skin contact
Irritant to skin and mucous membranes
Toxicity and irritation
  • Carcinogenic categories
  • IARC (International Agency for Research on Cancer) 3
  • NTP (National Toxicology Program) Substance is not listed.
  • OSHA-Ca (Occupational Safety Health Administration) Substance is not listed.
  • Alternative sources for toxicological information
  • No non-standard sources for toxicological information where used.

12. Ecological Information

Ecotoxicity
No further relevant information available.
Persistence and degradability
No further relevant information available.
Bioaccumulative potential
No further relevant information available.
Other adverse effects
  • General notes:
  • Water hazard class 1 (Assessment by list): slightly hazardous for water
  • Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.

13. Disposal Considerations

General information

  • Recommendation:
  • Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
  • Uncleaned packagings:
  • Recommendation: Disposal must be made according to official regulations.
  • Recommended cleansing agent: Water, if necessary with cleansing agents.

14. Transport Information

ADG label required

Class 3 Flammable liquid
Class 3 Flammable liquid
HAZCHEM
No further relevant information available.
UN Number
  • DOT, ADR UN1993
  • IMDG, IATA Void
Proper shipping name
  • DOT Flammable liquids, n.o.s. (2-Butoxy Ethanol)
  • ADR 1993 FLAMMABLE LIQUID, N.O.S. (2-Butoxy Ethanol)
  • IMDG, IATA Void
Transport hazard class
  • Class 3 Flammable liquids
  • Label 3
Packing group
Void
Environmental hazard
Not applicable
Additional information
  • Transport in bulk according to Annex II of
  • MARPOL73/78 and the IBC Code Not applicable.
  • Transport/Additional information:
  • DOT
  • Quantity limitations On passenger aircraft/rail: 1 L
  • On cargo aircraft only: 30 L
  • ADR
  • Excepted quantities (EQ) Code: E3
  • Maximum net quantity per inner packaging: 30 mL
  • Maximum net quantity per outer packaging: 300 mL
  • Special precautions for user Warning: Flammable liquids
  • Poison inhalation hazard: No
  • Hazard identification number (Kemler code): 30

15. Regulatory Information

No information provided.

16. Other Information

SDS preparation date
15 May 2026