SAFETY DATA SHEET

Acrylmount Hardener

Version 1Last reviewed 15 February 2023Catalogue: 1256-H, 1256-S, EMS1256

1. Identification

Product Identifiers

Product Name: Acrylmount Hardener
Other Names: Not available
Product Number(s): 1256-H, 1256-S, EMS1256
CAS Number: Not available

Recommended use of the chemical and restriction on use

Laboratory chemicals

Company Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

Emergency Contact Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

2. Hazards Identification

Classification of the substance or mixture

GHS08 Health hazard
Carc. 2 H351 Suspected of causing cancer.
STOT RE 2 H373 May cause damage to organs through prolonged or repeated exposure.
GHS07
Skin Irrit. 2 H315 Causes skin irritation.
Eye Irrit. 2A H319 Causes serious eye irritation.
Flam. Liq. 4 H227 Combustible liquid.

Label Elements

Signal Words: Warning
Hazard Statement(s): Hazard-determining components of labelling:
N,N-dimethyl-p-toluidine
Combustible liquid.
Causes skin irritation.
Causes serious eye irritation.
Suspected of causing cancer.
May cause damage to organs through prolonged or repeated exposure.
Precautionary Statement(s): Obtain special instructions before use.
Do not handle until all safety precautions have been read and understood.
Keep away from flames and hot surfaces - No smoking.
Do not breathe dust/fume/gas/mist/vapours/spray.
Wash thoroughly after handling.
Wear protective gloves/protective clothing/eye protection/face protection.

Primary route(s) of entry

Not available.

Human Health

Inhalation: If exposed or concerned: Get medical advice/attention.
Ingestion: Get medical advice/attention if you feel unwell.
Eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
Skin: Wash with plenty of water. Take off contaminated clothing and was it before reuse. If skin irritation occurs: Get medical advice/attention.

Environment

In case of fire: Use for extinction: CO₂, powder or water spray.
Store in a well-ventilated place. Keep cool.
Store locked up.
Dispose of contents/container in accordance with local/regional/national/international regulations.

3. Composition / Information on Ingredients

Name	CAS No.	Content (w/w)	Classification
Tetrahydrofurfuryl methacrylate	2455-24-5	>50-≤100%	Mixtures
methacrylic acid, monoester with propane-1,2-diol	27813-02-1	>25-≤50%	Mixtures
N,N-dimethyl-p-toluidine	99-97-8	≤2.5%	Mixtures

4. First Aid Measures

Ingestion: Call for a doctor immediately.
Inhalation: Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist.
In case of unconsciousness place patient stably in side position for transportation.
Skin Contact: Immediately wash with water and soap and rinse thoroughly.
Eye Contact: Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
Other Information: Symptoms of poisoning may even occur after several hours; therefore medical observation for a t least 48 hours after the accident.

5. Firefighting Measures

Suitable extinguishing equipment

Fire: CO₂, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
HAZCHEM: No further relevant information available.

Special protective equipment and precautions for fire fighters

Mouth respiratory protective device.

6. Accidental Release Measures

Personal precautions, protective equipment and emergency procedures: Not required.
Environmental precautions: Inform respective authorities in case of seepage into water course or sewage system.
Do not allow to enter sewers/surface or ground water.
Methods and materials for containment and clean up: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to item 13.
ensure adequate ventilation.

7. Handling and Storage

Precautions for safe handling: Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
Conditions for safe storage: Keep container tightly sealed.

8. Exposure Controls / Personal Protection

Exposure Standards

Engineering controls: Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.

Personal protective equipment

Eye and face protection: Tightly sealed goggles.
Skin protection: Wear protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Body protection: Wear protective clothing.
Respiratory protection: In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

9. Physical and Chemical Properties

General information

Appearance: Liquid, coloured according to product specifications.
Odour: Ester-like
pH: Not determined
Vapour Pressure: Not determined
Density: 1.033g/cm³
Boiling Point: 320°C
Melting Point: Undetermined
Solubility: Not miscible or difficult to mix.
Specific Gravity of Density: Not available.
Flash Point: 91°C
Flammable (Explosive) Limits: Not determined
Ignition Temperature: Product is not selfigniting.
Formula: Not available.

10. Stability and Reactivity

Reactivity: No further relevant information available.
Chemical stability: No decomposition if used according to specifications.
Possibility of hazardous reactions: No dangerous reactions known.
Conditions to avoid: No further relevant information available.
Incompatible materials: No further relevant information available.

11. Toxicological Information

Acute effects: Not available.
Eye contact: Irritating effect.
Skin contact: Irritant to skin and mucous membranes.
Ingestion: Not available.
Inhalation: No sensitising effects known.
Toxicity and irritation: Harmful
Irritant

12. Ecological Information

Ecotoxicity: Harmful to fish
Persistence and degradability: No further relevant information available.
Bioaccumulative potential: No further relevant information available.
Other adverse effects: Water hazard class 2: Hazardous for water.
Do not allow product to reach ground water, water course or sewage system.
Danger to drinking water if even small quantities leak into the ground.
Harmful to aquatic organisms.

13. Disposal Considerations

General information

Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Disposal must be made according to official regulations.

14. Transport Information

ADG label required

HAZCHEM: No further relevant information available.
UN Number: Not regulated.
Proper shipping name: Not regulated.
Transport hazard class: Not regulated.
Packing group: Not regulated.
Environmental hazard: Not applicable.
Special precautions for users: Not applicable.
Additional information: Not available.

15. Regulatory Information

Poisons Schedule Number: None of the ingredients is listed.
Other Information: A Chemical Safety Assessment has not been carried out.

16. Other Information

SDS preparation date: 15 February 2023
Comments: This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.