Do not allow to enter sewers/ surface or ground water.
Methods and materials for containment and clean up
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to section 13.
Ensure adequate ventilation.
Do not flush with water or aqueous cleansing agents.
Protective Action Criteria for Chemicals
PAC-1:
64-17-5 Ethyl alcohol 1,800 ppm
67-63-0 propan-2-ol 400 ppm
67-56-1 Methyl Alcohol 530 ppm
PAC-2:
64-17-5 Ethyl alcohol 3300* ppm
67-63-0 propan-2-ol 2000* ppm
67-56-1 Methyl Alcohol 2,100 ppm
PAC-3:
64-17-5 Ethyl alcohol 15000* ppm
67-63-0 propan-2-ol 12000** ppm
67-56-1 Methyl Alcohol 7200* ppm
7. Handling and Storage
Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
Information about protection against explosions and fires:
Keep ignition sources away - Do not smoke.
Protect from heat.
Protect against electrostatic charges.
Conditions for safe storage
Requirements to be met by storerooms and receptacles: Store in a cool location.
Information about storage in one common storage facility: Not required.
Further information about storage conditions:
Keep receptacle tightly sealed.
Store in cool, dry conditions in well sealed receptacles.
Protect from heat and direct sunlight.
Specific end use(s) No further relevant information available.
8. Exposure Controls / Personal Protection
Exposure Standards
Material
TWA ppm
TWA mg/m³
STEL ppm
STEL mg/m³
64-17-5 Ethyl alcohol
1000 ppm
1900 mg/m³
1000 ppm
1900 mg/m³
67-63-0 propan-2-ol
400 ppm
980 mg/m³
500 ppm
1225 mg/m³
67-56-1 Methyl Alcohol
200 ppm
260 mg/m³
250 ppm
325 mg/m³
Engineering controls
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
No further data; see section 7
Personal protective equipment
Eye and face protection
Tightly sealed goggles
Skin protection
Protection of hands:
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application.
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Body protection
protective clothing.
Respiratory protection
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use
respiratory protective device that is independent of circulating air.
9. Physical and Chemical Properties
General information
Appearance
Yellow Liquid
Odour
Alcohol like
pH
Mixture is non-polar/aprotic.
Vapour Pressure
(68 °F): 59 hPa (44.3 mm Hg) at 20 °C.
Density
50 °C (122 °F) at 20 °C
Boiling Point
78 °C (172.4 °F)
Melting Point
-113.8 °C (-172.8 °F)
Solubility
Fully miscible.
Specific Gravity of Density
Not available
Flash Point
14 °C (57.2 °F)
Flammable (Explosive) Limits
Lower: 3.5 Vol %
Upper: 15 Vol %
Ignition Temperature
Spontaneously flammable in air.
10. Stability and Reactivity
Reactivity
No further relevant information available
Chemical stability
Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications.
Possibility of hazardous reactions
Contact with water releases flammable gases.
Conditions to avoid
No further relevant information available.
Incompatible materials
No further relevant information available.
11. Toxicological Information
Acute effects
Information on toxicological effects
Acute toxicity:
LD/LC50 values that are relevant for classification:
64-17-5 Ethyl alcohol
Oral LD50 7,060 mg/kg (rat)
Inhalative LC50/4 h 20,000 mg/l (rat)
Eye contact
No irritating effect
Skin contact
No irritant effect.
Ingestion
No sensitizing effects known.
Inhalation
No sensitizing effects known.
Toxicity and irritation
Carcinogenic categories
IARC (International Agency for Research on Cancer)
64-17-5 Ethyl alcohol 1
67-63-0 propan-2-ol 3
NTP (National Toxicology Program)
None of the ingredients is listed.
OSHA-Ca (Occupational Safety Health Administration)
None of the ingredients is listed.
Alternative sources for toxicological information
No non-standard sources for toxicological information where used.
12. Ecological Information
Ecotoxicity
No further relevant information available.
Persistence and degradability
No further relevant information available.
Bioaccumulative potential
No further relevant information available.
Other adverse effects
No further relevant information available.
13. Disposal Considerations
General information
Waste treatment methods
Recommendation:
Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
Uncleaned packagings:
Recommendation: Disposal must be made according to official regulations.
Recommended cleansing agent: Water, if necessary with cleansing agents.