Inform respective authorities in case of seepage into a watercourse or sewage system.
Dilute with plenty of water.
Do not allow to enter sewers/surface or ground water.
Methods and materials for containment and clean up
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, or sawdust).
Use a neutralizing agent.
Dispose of contaminated material as waste according to section 13.
Ensure adequate ventilation.
7. Handling and Storage
Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols
Conditions for safe storage
Requirements to be met by storerooms and receptacles: No special requirements.
Information about storage in one common storage facility: Not required.
Further information about storage conditions: Keep the receptacle tightly sealed.
Specific end use(s) No further relevant information is available.
8. Exposure Controls / Personal Protection
Exposure Standards
Engineering controls
No further data; see section 7
Personal protective equipment
Eye and face protection
Avoid contact with the eyes and skin.
Tightly sealed goggles
Skin protection
Keep away from foodstuffs, beverages, and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Body protection
Protective gloves
The glove material has to be impermeable and resistant to the product, the substance, or the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/the preparation/the
chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Material of gloves
The selection of the suitable gloves does not only depend on the material but also on further marks of quality and
varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of
The glove material can not be calculated in advance and therefore has to be checked prior to the application.
Penetration time of glove material
The exact breakthrough through time has to be found out by the manufacturer of the protective gloves and has to be
observed
Respiratory protection
Breathing equipment:
In case of brief exposure or low pollution, use a respiratory filter device. In case of intensive or longer exposure, use
respiratory protective device that is independent of circulating air.
9. Physical and Chemical Properties
General information
Appearance
Colourless Liquid
Odour
Ammonia-like
pH
at 20 °C (68 °F): 13.8
Vapour Pressure
23 hPa (17.3 mm Hg)
Density
-
Boiling Point
100 °C (212 °F)
Melting Point
-72 °C (-97.6 °F)
Solubility
Fully miscible
Specific Gravity of Density
at 20 °C (68 °F): 0.9692 g/cm³ (8.08797 lbs/gal)
Flash Point
Not applicable.
Flammable (Explosive) Limits
Not flammable
Ignition Temperature
Product is not selfigniting
Formula
NH4OH
10. Stability and Reactivity
Reactivity
No further relevant information is available.
Chemical stability
Thermal decomposition/conditions to be avoided: No decomposition if used according to specifications.
Possibility of hazardous reactions
No dangerous reactions are known.
Conditions to avoid
No further relevant information is available.
Incompatible materials
No further relevant information is available.
No dangerous decomposition products are known.
11. Toxicological Information
Acute effects
No sensitizing effects known.
Eye contact
Strong caustic effect.
Strong irritant with the danger of severe eye injury
Skin contact
Strong caustic effect on skin and mucous membranes
Ingestion
Swallowing will lead to a strong caustic effect on the mouth and throat and to the danger of perforation of the esophagus and stomach.
Toxicity and irritation
The product shows the following dangers according to internally approved calculation methods for preparations:
Corrosive
Irritant
12. Ecological Information
Ecotoxicity
· Aquatic toxicity: No further relevant information is available
Persistence and degradability
No further relevant information is available
Bioaccumulative potential
No further relevant information is available
Other adverse effects
General notes:
Water hazard class 2 (Self-assessment): hazardous for water
Do not allow the product to reach groundwater, a watercourse, or a sewage system.
Must not reach bodies of water or drainage ditches undiluted or unneutralized.
Danger to drinking water if even small quantities leak into the ground.
Also poisonous for fish and plankton in water bodies.
Very toxic for aquatic organisms
Rinsing off bigger amounts into drains or the aquatic environment may lead to increased pH-values. A high pH value harms aquatic organisms. In the dilution of the use-level, the pH value is considerably reduced so that after the use of the product, the aqueous waste, emptied into drains, is only low-water dangerous.
13. Disposal Considerations
General information
Must not be disposed of together with household garbage. Do not allow the product to reach the sewage system.
Uncleaned packagings:
Recommendation: Disposal must be made according to official regulations.
Recommended cleansing agent: Water, if necessary, with cleansing agents.
If swallowed: Rinse mouth. Do NOT induce vomiting.
If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water [or shower].
If inhaled: Remove person to fresh air and keep comfortable for breathing.
If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
Continue rinsing.
Immediately call a poison center/doctor.
Specific treatment (see on this label).
Wash contaminated clothing before reuse.
Store locked up.
Dispose of contents/container in accordance with local/regional/national/international regulations.
Chemical safety assessment: A chemical safety assessment has not been carried out.
16. Other Information
SDS preparation date
15 February 2026
Comments
** This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
Abbreviations and acronyms:
ADR: Accord relatif au transport international des marchandises dangereuses par route (European Agreement Concerning the International
Carriage of Dangerous Goods by Road)
IMDG: International Maritime Code for Dangerous Goods
DOT: US Department of Transportation
IATA: International Air Transport Association
EINECS: European Inventory of Existing Commercial Chemical Substances
ELINCS: European List of Notified Chemical Substances
CAS: Chemical Abstracts Service (division of the American Chemical Society)
NFPA: National Fire Protection Association (USA)
HMIS: Hazardous Materials Identification System (USA)