SAFETY DATA SHEET

Kodak Rapid Fixer

Version 1Last reviewed 2 October 2023Catalogue: 74312, EMS74312

1. Identification

Product Identifiers

Product Name: Kodak Rapid Fixer
Other Names: Not available
Product Number(s): 74312, EMS74312
CAS Number: Not available

Recommended use of the chemical and restriction on use

Laboratory chemicals.

Company Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

Emergency Contact Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

2. Hazards Identification

Classification of the substance or mixture

GHS08 Health hazard.
Repr. 2 H361 Suspected of damaging fertility or the unborn child.
GHS07 Eye Irrit. 2A H319 Causes serious eye irritation.

Label Elements

Signal Words: Warning
Hazard Statement(s): Causes serious eye irritation.
Suspected of damaging fertility or the unborn child.
Precautionary Statement(s): Obtain special instructions before use.
Do not handle until all safety precautions have been read and understood.
Wash thoroughly after handling.
Wear protective gloves/protective clothing/eye protection/face protection.

Primary route(s) of entry

Not available.

Human Health

Inhalation: If exposed or concerned: Get medical advice/attention.
Ingestion: If exposed or concerned: Get medical advice/attention.
Eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
Skin: If exposed or concerned: Get medical advice/attention.

Environment

Store locked up.
Dispose of contents/container in accordance with local/regional/national/international regulations.
Contact with acids liberated toxic gas.

3. Composition / Information on Ingredients

Name	CAS No.	Content (w/w)	Classification
Acetic Acid Glacial	64-19-7	≤2.5%	Not Available
sodium hydrogensulphite...%	Not Available	≤2.5%	Not Available
BORIC ACID	10043-35-3	≤2.5%	Not Available
ammonium sulphite	10196-04-0	≤2.5%	Not Available

4. First Aid Measures

Ingestion: If symptoms persist consult doctor.
Inhalation: In case of unconsciousness place patient stably in side position for transportation.
Skin Contact: Immediately wash with water and soap and rinse thoroughly.
Eye Contact: Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
Other Information: No further relevant information available.

5. Firefighting Measures

Suitable extinguishing equipment

Fire: Use fire extinguishing methods suitable to surrounding conditions.
HAZCHEM: No further relevant information available.

Special protective equipment and precautions for fire fighters

Mouth respiratory protective device.

6. Accidental Release Measures

Personal precautions, protective equipment and emergency procedures: Mouth respiratory protective device.
Environmental precautions: Dilute with plenty of water.
Do not allow to enter sewers/surface or ground water.
Methods and materials for containment and clean up: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Ensure adequate ventilation.

7. Handling and Storage

Precautions for safe handling: Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
Conditions for safe storage: Do not store together with acids. Keep container tightly sealed.

8. Exposure Controls / Personal Protection

Exposure Standards

Material	TWA ppm	TWA mg/m³	STEL ppm	STEL mg/m³
64-19-7 Acetic Acid Glacial	10ppm	25mg/m³	15ppm	37mg/m³
7631-90-5 sodium hydrogensulphite...%		5mg/m³

Engineering controls: Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.

Personal protective equipment

Eye and face protection: Tightly sealed goggles.
Skin protection: Protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Body protection: Protective clothing.
Respiratory protection: In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

9. Physical and Chemical Properties

General information

Appearance: Yellow liquid
Odour: Sulfurous
pH: 5
Vapour Pressure: 23hPa
Density: 0.6g/cm³
Boiling Point: >100 °C
Melting Point: Undetermined
Solubility: Fully miscible
Specific Gravity of Density: Not available.
Flash Point: Not applicable.
Flammable (Explosive) Limits: Not determined.
Ignition Temperature: Not available.
Formula: Not available.

10. Stability and Reactivity

Reactivity: No further relevant information available.
Chemical stability: No decomposition if used according to specifications.
Possibility of hazardous reactions: Contact with acids releases toxic gases.
Conditions to avoid: No further relevant information available.
Incompatible materials: No further relevant information available.

11. Toxicological Information

Acute effects: Not available.
Eye contact: Irritating effect.
Skin contact: Irritant to skin and mucous membranes.
Ingestion: Not available.
Inhalation: No sensitising effects known.
Toxicity and irritation: Irritant

12. Ecological Information

Ecotoxicity: No further relevant information available.
Persistence and degradability: No further relevant information available.
Bioaccumulative potential: No further relevant information available.
Other adverse effects: Water hazard class 1: slightly hazardous for water.
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.

13. Disposal Considerations

General information

Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Disposal must be made according to official regulations.
Recommended cleansing agents: Water, if necessary together with cleansing agents.

14. Transport Information

ADG label required

HAZCHEM: No further relevant information available.
UN Number: Not regulated
Proper shipping name: Not regulated
Transport hazard class: Not regulated
Packing group: Not regulated
Environmental hazard: Not applicable
Special precautions for users: Not applicable
Additional information: Not regulated.

15. Regulatory Information

Poisons Schedule Number: 64-19-7 Acetic Acid Glacial S2, S5, S6
10043-35-3 BORIC ACID S5
Other Information: A Chemical Safety Assessment has not been carried out.

16. Other Information

SDS preparation date: 2 October 2023
Comments: This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.