Do not allow to enter sewers/ surface or ground water.
Methods and materials for containment and clean up
Use neutralising agent.
Dispose contaminated material as waste according to item 13.
Ensure adequate ventilation.
Protective Action Criteria for Chemicals
PAC-1: 6.00E-04 ppm
PAC-2: 0.0084 ppm
PAC-3: 4.0 ppm
7. Handling and Storage
Precautions for safe handling
Thorough dedusting.
Ensure good ventilation/exhaustion at the workplace.
Open and handle receptacle with care.
Keep respiratory protective device available.
Conditions for safe storage
Store locked up.
Store in a well-ventilated place. Keep container tightly closed.
8. Exposure Controls / Personal Protection
Exposure Standards
Material
TWA ppm
TWA mg/m³
STEL ppm
STEL mg/m³
Osmium Tetroxide
0.0002 ppm
0.0016 mg/m³-
0.0006 ppm
0.0047 mg/m³
Engineering controls
No special requirements.
Personal protective equipment
Eye and face protection
Tightly sealed goggles
Skin protection
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation ·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. ·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observe.
Body protection
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Store protective clothing separately.
Avoid contact with the eyes and skin.
Respiratory protection
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device
9. Physical and Chemical Properties
General information
Appearance
Light yellow crystalline
Odour
Like chlorine
pH
6-7
Vapour Pressure
at 20 °C (68 °F): 10 hPa (7.5 mm Hg)
Density
at 20 °C (68 °F): 4.906 g/cm³ (40.94057 lbs/gal)
Boiling Point
130 °C (266 °F)
Melting Point
40.1 °C (104.2 °F)
Solubility
Insoluble.
Specific Gravity of Density
Not applicable
Flash Point
Not applicable
Flammable (Explosive) Limits
Not determined
Ignition Temperature
Not determined
Formula
Not available
10. Stability and Reactivity
Reactivity
No further relevant information available.
Chemical stability
No decomposition if used according to specifications.
Possibility of hazardous reactions
No dangerous reactions known.
Conditions to avoid
No further relevant information available.
Incompatible materials
No further relevant information available.
11. Toxicological Information
Acute effects
No further relevant information available.
Eye contact
Strong caustic effect.
Skin contact
Caustic effect on skin and mucous membranes.
Ingestion
Danger through skin adsorption.
Swallowing will lead to a strong caustic effect on mouth and throat and to the danger of perforation of esophagus and stomach.
Inhalation
No sensitising effects known.
Toxicity and irritation
Carcinogenic categories
IARC (International Agency for Research on Cancer) Substance is not listed.
NTP (National Toxicology Program) Substance is not listed.
OSHA-Ca (Occupational Safety Health Administration) Substance is not listed.
12. Ecological Information
Ecotoxicity
No further relevant information available.
Persistence and degradability
No further relevant information available.
Bioaccumulative potential
No further relevant information available.
Other adverse effects
Water hazard class 2 (German Regulation) (Self-assessment): hazardous for water
Do not allow product to reach ground water, water course or sewage system.
Must not reach sewage water or drainage ditch undiluted or unneutralisd.
Danger to drinking water if even small quantities leak into the ground.
13. Disposal Considerations
General information
Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Recommendation: Disposal must be made according to official regulations
14. Transport Information
ADG label required
Class 6.1 Toxic
HAZCHEM
Not available.
UN Number
UN2471
Proper shipping name
2471 OSMIUM TETROXIDE
Transport hazard class
6.1
Packing group
Not regulated.
Environmental hazard
Not applicable.
Special precautions for users
Warning: Toxic substances
Additional information
Hazard identification number (Kemler code): 66
EMS Number: F-A,S-A
Stowage Category B
Stowage Code SW2 Clear of living quarters
Transport in bulk according to Annex II of
MARPOL73/78 and the IBC Code Not applicable.
Quantity limitations On passenger aircraft/rail: 5 kg
On cargo aircraft only: 50 kg
Hazardous substance: 1000 lbs, 454 kg
Remarks: Special marking with the symbol (fish and tree)
Excepted quantities (EQ) Code: E5
Maximum net quantity per inner packaging: 1 g
Maximum net quantity per outer packaging: 300 g
15. Regulatory Information
Poisons Schedule Number
Substance is not listed.
Other Information
No further relevant information available.
16. Other Information
SDS preparation date
25 February 2026
Comments
This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.